Item specifics:

Use:Promotional Pen

Product Description:

Delivery time:

Most of the iteam shipping in 7 working days.

Specifications and parameters:

 Discharging mode:Hot melt extrusion molding

Molding:Three-dimensional molding

Print range:Unlimited

Spinning speed:Adjustable

Temperature:60 - 230  adjustable

Working voltage:12V 3A equipment

The nozzle diameter:0.4mm

Product function diagram: 

Import and export

The power indicator light

Work indicating lamp

Temperature adjustment holes

Speed control switch

The power input hole

Wire back button

Wire button

Integrated nozzle heating head

Warning! 

1 this equipment is suitable for children over 8 years of age and adult use. Children need to be used in the adult guardianship. 

2 the equipment for high temperature near the anterior tip and dangerous region, the highest temperature at 230, therefore no pen touch other objects by hand touch. 

3 it is strictly prohibited to use foreign body into the feed hole

4 prohibited the use of power of the company to provide the adapter

5 is strictly prohibited the use of non supplies provided by this Corporation

6 the equipment for precision electronic instruments, do not water

7 please put it in a safe place, to prevent falling from high altitude or the children touch. 

Operating instructions:

1 the power adapter AC power line into the mains socket, the other end of the DC plug into the drawing pen is only "power input hole". The Yellow LED lights, shows that the equipment has power to enter the standby servo state. 

2. The LCD screen display words "" or "", choose "material selection, material selection. " from the LCD screen. The selection must be same as the material attribute consistent, in order to avoid failure

3 click "wire" button, the red LED lights, shows that the equipment has entered the warm-up state. About 0.5-2 minutes later. When the red LED lights from red to blue. Show end of preheating, equipment can work normally. 

4 the consumable insert the pen end only "supplies introduction hole", brought received long press "wire" button, random supplies of conveying equipment from the built-in motor. When the nozzle end with the compound NIB out shall be reproduced successfully. * *

5. The 4 creation. (this equipment with stepless speed regulating function, in the creation process, according to the pen speed to adjust the amount of glue. Without both hands. )

6. Homogeneous materials have different melting points because of the different colors. Please according to the silking to timely tune temperature. (the material melting point judgement and temperature adjustment Please refer to " temperature tuning")

7. The use of the process it is forbidden to touch the head and the heating component. 

8. When the device is not more than 5 minutes, will automatically enter standby state of sleep. This "light" out. If you need to use, click "wire" button to trigger. 

9 need to back wire or replacement supplies, please repeat (2), and then press "wire back button". 

"*": Heating time by setting temperature and the influence of environmental temperature

"* *": The installation of consumables money must take supplies some use a knife to cut

"* * *": After each use to uninstall back wire

Material change:

1. When the need to replace the homogeneity of different color of consumables, we can choose to continue loading and unloading filament. No matter which way are required to ensure the loading port smooth supplies

2. When change the material from PLA to ABS materials, uninstall the ABS materials, restart your device (unplugged), through the "material selection / tempering" button to ABS mode, and then loading ABS. 

3. when change the material from ABS into PLA material, due to melting point of ABS material is much higher than the PLA material, if used improperly, most likely caused by nozzle clogging or equipment damage. The correct way is: In the ABS mode, carry back wire uninstall, reboot the device, through the selection of materials / tempering "button to PLA mode. Then carry heating period quickly right after "PLA" material loading. (this step is very important! )